Circutor CPM (Available until stocks) Manual de usuario

MULTIMETER CURRENT CLAMP CPM (Code: M80430) INSTRUCTION MANUAL ( M98111201-03-10A )  CIRCUTOR S.A.

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 9 - Symbols: The analyzer is protected by double or reinforced insulation. Caution

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 10 - 2.2.- Special precautions  This equipment can be used for Overvoltage Catego

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 11 - 3.- INSTRUCTIONS FOR USE 3.1.- Description of controls and elements A B

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 12 - [1] Rotary function switch Analyzer off DC voltage measurement, range 6

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 13 - [3] V input terminal for AC/DC voltage measurement [4] COM common input term

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 14 - 3.2.- Use ATTENTION When the value to be measured is unknown always place t

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 15 - 3.2.2.- Current measurement 1. Set the rotary switch [1] to the desired higher

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 16 - 3.2.4.- Frequency measurement 1. Set the rotary switch [1] to the Hz position.

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 17 - 3.2.6.- Diode test 1. Connect the black test probe to the COM terminal [4] an

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 18 - 4.- MAINTENANCE Attention : Disconnect the test probes before changing the

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 1 - CPM ANALYZER INDEX page no. SAFETY NOTES Before using the equip

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 19 - Caution : Do not use aromatic hydrocarbons or chlorinated solvents for clea

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 2 - The analyzer is powered by a 9 V battery. Its design and its double insulation m

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 3 - 1.2.- Specifications Display 3 ½ digit LCD display with a maximum reading of

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 4 - Power Supply 9 V, IEC 6F22 battery. Battery life Typically 200 hours for a zi

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 5 - DC Voltage Range Accuracy Input impedance Overload protection 600 V ±

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 6 - Continuity Sound alarm Overload protection Less than 30Ω in the range of 2

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 7 - 700 A AC Max. during 1 minute.

--------- MULTIMETER CURRENT CLAMP CPM -------- PG No. 8 - 2.- SAFETY REQUIREMENTS 2.1.- General  This equipment can be used in envir