Circutor CEM-C30 series Manual de usuario descargar pdf (Pagina 25)

To write or modify the value, short press the button

repeatedly, increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit with a long press on

the button, allowing the remaining values to be modied.

To validate the data, move to the last digit and long press the button; the validation screen

will appear (Figure 13) indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 13 , the system returns to the

Peripheral address programming main screen.

Minimum value: 1.

Maximum value: 254

Short press the button to access the next programming step.

4�7�4� Transmission speed ( Baud rate)

NB: This is only displayed if there is a CEM M-RS485 (communications interface for the CEM

family of units) connected to the unit.

This is the home screen for entering the transmission speed.

Long press the button to view the value to be programmed.

The transmission speed (Baud rate) is selected on this screen,

and may be: 9600, 19200 or 38400�

Short press the

button to browse the different options.

To validate the data, long press the button and the validation screen will appear

(Figure 13) indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 13 , the system returns to the

Transmission speed programming main screen.

Short press the button to access the next programming step.

Instruction Manual

CEM-C30

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 41 42

Sin comentarios

Circutor CEM-C30 series Manual de usuario Pagina 25