Circutor CEM-C10 series Manual de usuario descargar pdf (Pagina 20)

4.7.- CONFIGURATION

In the setup menu you can:

 Program the weight and type of impulse output.

 Program the communications.

 Program the display screen.

 Program the cost of the energy and the CO

emissions

 Delete the partial energy meters.

The standby mode is activated again when no key is pressed for 60 seconds.

Long press the key in the standby mode screen to open these setup screens. Short press

the key to display the home screen, Figure 10:

Figure 10: Programming home screen

Long press the key to access the rst programming step.

4�7�1� Impulse output weight

This is the home screen for entering the weight of the impulse

output.

Long press the key to view the value to be programmed.

To write or modify the value, short press the key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit with a long press on

the key, allowing the remaining values to be modied.

To validate the data, move to the last digit and long press the key; the validation screen

will appear (Figure 11) indicating that the programming value has been saved.

CEM-C10

Instruction Manual

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

Sin comentarios

Circutor CEM-C10 series Manual de usuario Pagina 20