Circutor CEM-C10 series Manual de usuario descargar pdf (Pagina 27)

To write or modify the value, short press the key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit with a long press on

the key, allowing the remaining values to be modied.

To validate the data, move to the last digit and long press the key; the validation screen

will appear (Figure 11) indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 11, the system returns to the CO

emissions programming main screen.

Minimum value: 0.000

Maximum value: 9.000

Short press the key to access the next programming step.

4�7�10� Deleting the partial energy meters

NB: It is only displayed if the partial energy display has been selected.

On this screen you select whether or not to delete the partial

energy meters.

Long press the

key to delete the energy meters. The

validation screen (

Figure 11) will be displayed next, indicating that

the energy meters were deleted correctly.

After a few seconds viewing the screen shown on Figure 11 , the system returns to the Partial

energy meter deletion programming main screen.

4�7�11� Exiting the setup menu

When this screen is displayed:

Long press the

key to exit the setup menu.

Short press the

key to return to the rst setup point ( “4.7.1.

Impulse output weight”

Instruction Manual

CEM-C10

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 35 36

Sin comentarios

Circutor CEM-C10 series Manual de usuario Pagina 27