Circutor CEM-C10 series Manual de usuario descargar pdf (Pagina 22)

To write or modify the value, short press the key repeatedly,

increasing the value of the ashing digit.

When the desired value is shown on the screen, move onto the next digit with a long press on

the key, allowing the remaining values to be modied.

To validate the data, move to the last digit and long press the key; the validation screen

will appear (Figure 11) indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 11 , the system returns to the

Peripheral address programming main screen.

Minimum value: 1.

Maximum value: 254

Short press the key to access the next programming step

4�7�4� Transmission speed ( Baud rate)

NB: This is only displayed if there is a CEM M-RS485 (communications interface for the CEM

family of units) connected to the unit.

This is the home screen for entering the transmission speed.

Long press the key to view the value to be programmed.

The transmission speed (Baud rate) is selected on this screen,

and may be: 9600, 19200 or 38400�

Short press the

key to browse the different options.

To validate the data, long press the key and the validation screen will appear (Figure 11)

indicating that the programming value has been saved.

After a few seconds viewing the screen shown on Figure 11, the system returns to the

Transmission speed programming main screen.

Short press the key to access the next programming step.

CEM-C10

Instruction Manual

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Sin comentarios

Circutor CEM-C10 series Manual de usuario Pagina 22