Circutor PowerStudio Series Manual de usuario descargar pdf (Pagina 78)

PowerStudio PowerStudio

78 User Manual

1.19- TCP2RS CONVERTER

The TCP2RS converter connects equipment units that work with serial communication (RS-232

/ RS-485) to an Ethernet network using the IP protocol.

When adding or modifying this device, see ‘Editor Manual’, the following dialogue appears

Where

• Name: Alphanumeric field that uniquely identifies the device throughout the program. There

are no two devices in the configuration with the same name.

• Description: Alphanumeric type data to enter a brief description of the device.

• Address converter: Corresponds to the address the program uses to communicate with the

device. This parameter can be an IP address or a name.This address should not be confused

with the MAC address.

• Port: Corresponds to the communications port:

• Configuration port: Corresponds to the communication port the program uses to configure

the device. This port is 30718 by default.

For a TCP2RS device to be able to communicate through a router, perform the following

steps:

1-In the ‘Address converter‘ field enter the router's IP address.

2 - In the ‘Port” field enter the communications port and redirect this port on the router to the

device's communications port.

3 - Redirect the configuration port on the router to port 30718 of the converter.

N.B.: For information on re-addressing ports consult the router user manual.

• Parameters: By clicking the button a dialogue will appear where a number of parameters of

the device can be configured.

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 291 292

Sin comentarios

Circutor PowerStudio Series Manual de usuario Pagina 78