Circutor REC3 Series Manual de usuario descargar pdf (Pagina 16)

4�- START-UP

Once the unit is installed you must carry out the following start-up sequence for it to work prop-

erly.

4.1.- AUTOMATIC MODE

If the unit is going to operate in automatic mode, see Section “5.2.- AUTOMATIC” . The start-up

sequence is:

1�- Put the mode selector switch in Manual Mode (OFF).

2�- Lift the RCCB cover.

3�- Put the RCCB contact in ON mode.

4�- Lower the RCCB cover.

5�- Put the mode selector switch in Automatic Mode (ON).

Note: The switch has an M2 hole where you can attach a seal or a padlock to block ac-

cess to the RCCB and any other attempts at manual reclosing (Figure 10).

Figure 10: Switch's M2 hole to seal access to the RCCB�

4.2.- MANUAL MODE

If the unit is going to operate in manual mode, see Section “5.1.- MANUAL” . The start-up se-

quence is:

1�- Put the mode selector switch in Manual Mode (OFF).

2�- Lift the RCCB cover.

3�- Put the RCCB contact in OFF mode.

4�- Lower the RCCB cover (optional).

Instruction Manual

REC 3 - REC 3C

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 25 26

Sin comentarios

Circutor REC3 Series Manual de usuario Pagina 16